Analysis of multiaxial impact behavior of polymers

Abstract

AbstractImpact performance is a primary concern in many applications of polymers. In this paper, finite element analysis (FEA) and ABAQUS/Explicit are used to simulate the deformation and failure of polymers in the standard ASTM D3763 multiaxial impact test. The specimen geometry and loading mode in this multiaxial impact test provides a close correlation with practical impact conditions. A previously developed constitutive model (“DSGZ” model) for polymers under monotonic compressive loading is generalized and extended for any loading mode and takes into account the different behavior of polymers in uniaxial tensile and compression tests. The phenomenon of thermomechanical coupling during plastic deformation is also included in the analysis. This generalized DSGZ model, along with thermomechanical coupling and a failure criterion based on maximum plastic strain, is incorporated in the FEA model as a coupled‐field user material subroutine to produce a unique tool for the prediction of the impact behavior of polymeric materials. Load‐displacement curves from FEA simulations are compared with experimental data for two glassy polymers, ABS‐1 and ABS‐2. The simulations and experimental data are in excellent agreement up to the maximum impact load. It is shown that not accounting for the different behavior of the polymer in uniaxial tensile and compression tests and thermomechanical coupling effects leads to an overestimation of the load and impact energy, especially at large displacements and plastic deformations. Friction also plays an important role in the impact behavior. If one neglects the friction between the striker and polymer disk, the predicted impact loads are lower as compared with experimental data at large displacements.