Abstract

In order to solve the calculation of the micro-segment gear's contact stress, Ansys (one FEM software) is used here. First the model of the gear is set up in Catia(one 3D modeling software), then the model is imported to Ansys from Catia, and the result of contact stress is got in Ansys. The contrasting analysis of in volute gear and micro-segment gear with the same parameters are shown in the paper. The results show that the micro-segment gear's contact stress can be solved in Ansys and micro-segments in volute gear has lower contact stress. Thus the micro-segment gear is better than the in volute gear.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.