Abstract
The influence of parameters on load distribution between teeth of HCR involute spur gear was studied. The load distribution was studied and verified theoretically by test. Under the condition of given parameter, the change curve of load distribution and maximum load sharing rate were studied when addendum coefficient, pressure angle, tooth number, modification coefficient and base pitch error respectively changed. The test result show that, under high loads, the maximum load sharing rate are linearly correlation to addendum coefficient, pressure angle, modification coefficient and base pitch error. With the increase of the number of teeth, the change rate of the maximum load sharing rate decreases from large to small, then tends to be flat. The rate of change in load sharing at the point of tooth engagement is small when the top height co-efficient, pressure angle, number of teeth and coefficient of variation change, and relatively large when the base joint deviation changes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
