Abstract

AbstractA solid oxide fuel cell (SOFC) stack can exhibit both anodic and cathodic leakages, i.e. a fuel leak from the anode side and an air leak from the cathode side of the stack, respectively. This study describes the results of an in‐situ leakage analysis conducted for a planar SOFC stack during 2000 hours of operation in an actual system environment. The leakages are quantified experimentally at nominal system operating conditions by conducting composition analysis and flow metering of gases for both fuel and air subsystems. Based on the calculated atomic hydrogen‐to‐carbon ratio of the fuel and air gases, it is found that the fuel leakages are mostly selective by nature: the leaking fuel gas does not have the same composition as the fuel system gas. A simple diffusive leakage model, based on the leakage being driven by concentration differences weighted by diffusion coefficients, is applied to quantify the amount of leakages. The leakage model provides a good correspondence with the experimental results of the gas analysis.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.