Abstract

The efficiency of modern Turbofan engines can be significantly increased by using a gearbox between compressor and turbine of the low pressure section. Rotational speed of the low pressure turbine (LPT) in a Geared Turbofan is much higher than in normal LPT’s which lead to necessary adjustments in blade design. This work has investigated the transition behavior of a modified profile geometry for low-loss at engine cruise conditions. Typical LPT conditions have thus been chosen as baseline for the experimental work. A pressure distribution has been created on a flat plate by means of contoured walls in a low speed wind tunnel. The paper will analyze the experimental results and show additionally the numerical predictions of the test case. The experimental part of this paper describe how the blade was Mach number scaled to obtain the geometry of the wind tunnel wall contour. The pressure distribution for the incompressible test case show a very good agreement to the compressible case. Boundary layer (BL) measurements with hot-wire-anemometry have been performed at high spatial resolution under a freestream turbulence of almost 8%. Different Reynolds numbers have been investigated and will be compared with special attention being paid to the transition on the suction side by contour plots (turbulence levels, turbulent intermittency) and integral BL parameters. It was found that the transition on the suction side is not completed for small Reynolds numbers but takes place at higher velocities. In the numerical part studies by means of steady RANS simulations with k-ω – SST turbulence model and γ-Reθ transition model have been conducted. The aim is to validate the RANS solver for the low-loss LPT application. Hence, comparison is made to the measured data and the transitional behavior of the BL. Furthermore, additional parameter variations have been conducted (turbulence intensity and Reynolds number). The numerical investigations show partially a good comparison for the BL development indicating the different transition modi with increasing Reynolds number and turbulence intensity.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.