Abstract
It is well known that a specimen for impact testing must be optimized in terms of its dimensions. The main reason is to reduce strain gradients due to the effects of elastic–plastic wave propagation. On the other hand, when a split Hopkinson bar in tension is applied, the net displacement of the specimen ends is very limited, usually from 2.0 to 3.0 mm. Thus, to reach a maximum strain of 0.5 the specimen length must be reduced in dimensions from 4.0 to 6.0 mm. Consequently, small diameters or lateral dimensions and lengths must be applied to assure one-dimensional deformation. Such small lengths substantially perturb the determination of real material behavior. So the main motivation of this study was to perform a systematic analysis, numerical and analytical, to find differences in the behavior of short and long specimens loaded in impact tension. The finite element code ABAQUS/Explicit has been used to simulate several specimen lengths from 10 to 40 mm submitted to impact velocities ranging from 10 to 100 m/s.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
