Abstract
This paper aims to study the effect of surge radiation by a vertically hollow cylinder floating in a two-layer fluid of finite depth. Since most of the important characteristics of the oscillating water column are preserved by the hollow cylindrical structure, so the proposed device can be considered as an oscillating water column (OWC) which is one of the important wave energy device. In this two-layer fluid system, the upper layer is bounded above by a free surface and the lower layer is bounded below by a solid impermeable bottom, and the submerged hollow cylindrical structure allows it to oscillate in a surge mode of motion in the upper layer. On the assumption that wave amplitudes are small in comparison to wavelengths, hence the linear water wave theory is applied to formulate boundary value problems by dividing whole domain into 2 sub-domains. The formulated boundary value problems for surge radiated potentials in each sub-domain; we execute to obtain solutions in each sub-domain by using variable separation and matched eigenfunction expansion methods. With the help of obtained surge radiated potentials, we derive the radiation forces by the device in terms of added mass and damping coefficients. A set of influences of different parameters of the device on the added mass and damping coefficients are demonstrated in both surface and internal wave modes of motion. Hydrodynamic coefficients oscillate highly near a particular frequency, which leads to the resonance phenomena. In addition to that, the 3D plots of the free surface elevation in surface and internal wave modes are presented. A density ratio γ = 0.97 has a higher oscillation than a density ratio γ = 0.93, 0.95. High oscillations occur around a particular frequency ω = 3.83 due to the resonance phenomenon in which the waves incoming match with the natural motion of the object. HIGHLIGHTS A floating hollow vertical cylindrical structure is considered in a two-layer fluid system having finite depth The separation of variables and matched eigenfunction expansion methods are utilized to obtain the solutions to the boundary-value problems The diffracted velocity potentials under the surge mode of motion are evaluated in the identified regions The added mass, damping coefficients, free surface and interface elevations in surface and internal wave modes are evaluated with different set of parameters of the device A number of results are presented regarding the effect of parameters of the device on the added mass, damping coefficients, free surface and interface elevations It is observed that the density ratio of the two-layer fluid has significant effect on the added mass, damping coefficient and the elevations GRAPHICAL ABSTRACT
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.