Analysis of glenoid inter-anchor distance with an all-suture anchor system

Abstract

BackgroundAll-suture anchors used in arthroscopic shoulder stabilization employ small diameter anchors, which allow greater placement density on narrow surfaces such as the glenoid. There is no consensus in the literature about how close to one another two anchors may be implanted. PurposeThe purpose of the present study is to compare the strength characteristics of two all-suture anchors placed in cadaveric human glenoid at variable distances to one another, in order to determine the minimum distance required for optimal strength. MethodsTwelve fresh-frozen human cadaveric glenoids were implanted with 1.4 mm all-suture anchors at varying inter-anchor distances. Each glenoid was used for four tests, for a total of 48 tests. Anchors were implanted adjacent to one another or with 2, 3, or 5 mm bone bridges between pilot holes. The glenoids then underwent pullout testing using a test frame with a 5N preload followed by displacement of 12.5 mm/s. The primary outcomes were stiffness, failure strength, and ultimate strength. ResultsStiffness was 13.52 ± 3.8, 17.97 ± 5.02, 17.59 ± 4.65 and 18.95 ± 4.67 N/mm for the adjacent, 2, 3, and 5 mm treatment groups, respectively. The adjacent group had a significantly lower stiffness compared to the other treatment groups. Failure strength was 48.68 ± 20.64, 76.16 ± 23.78, 73.19 ± 35.83 and 87.04 ± 34.67 N for the adjacent, 2, 3, and 5 mm treatment groups, respectively. The adjacent group had a significantly lower failure strength compared to the other treatment groups. Ultimate strength was also measured to be 190.59 ± 140.93, 268.7 ± 115.1, 283.23 ± 118.43, and 291.28 ± 118.24 for the adjacent, 2, 3, and 5 mm treatment groups, respectively. ConclusionsThis biomechanical study provides evidence that 1.4 mm all-suture anchors demonstrate similar strength characteristics when placed at least 2 mm or greater from one another. When 1.4 mm all-suture anchors were placed adjacent to one another, there was an observed decrease in failure strength and stiffness. Clinical relevanceThis study suggests that 1.4 mm all-suture anchors may be placed as close as 2 mm to one another while preserving strength characteristics.