Analysis of Geophysical Well Logs Obtained in the State 2–14 Borehole, Salton Sea Geothermal Area, California

Abstract

A complete suite of conventional geophysical well logs was obtained in the upper part of a 3220‐m‐ deep borehole drilled into geothermally altered alluvial sediments on the southeastern edge of the Salton Sea. In situ temperatures greater than 300°C and an inability to cool parts of the borehole by circulation limited the suite of logs run below 2000 m in depth to deep induction, spontaneous potential, un‐calibrated neutron, natural gamma, and temperature. Bottom‐hole temperature trends given by repeat temperature logs were extrapolated to undisturbed temperatures approaching 355°C at a depth of 3220 m. Geophysical logs obtained in the State 2–14 borehole indicate that neutron porosity, gamma‐gamma, and deep‐induction logs provide useful information on lithologic trends with depth. The natural gamma log contains almost continuous, high‐frequency fluctuations that obscure lithologic trends and that may be related to recent radioisotope redistribution and departure from radiometric equilibrium. Acoustic transit time logs give unrealistically low in situ compressional velocities ranging from 1.8 to 3.0 km/s, whereas acoustic waveform logs indicate that sediment compressional velocities range from less than 3.0 km/s shallower than 1000 m in depth to almost 5.0 km/s at depths greater than 2000 m. Analyses indicate that most log values lie between two lithologic end points: an electrically conductive claystone with moderate neutron porosity, but no effective porosity, and an electrically nonconductive, fully cemented siltstone that has small but finite porosity. A limited number of clean sandstones depart from this trend; geophysical logs from these sandstones indicate an effective porosity ranging from 5 to 14%, and saturation with brines having equivalent NaCl concentrations greater than 100,000 mg/L. Depth‐ averaged trends in neutron porosity and deep‐induction logs, along with trends in acoustic velocity determined from acoustic waveform logs, demonstrate that major changes in the properties of alluvial sediments occur within the depth range from 1200 to 1800 m. Although caliper logs were not obtained deeper than 2000 m, resistivity values less than 10 ohm m at those depths probably correspond to borehole enlargements in production zones rather than local increases in effective porosity. The transition in sediment properties indicated by the geophysical logs in the depth interval from 1200 to 2000 m apparently represents a detailed vertical profile of the transition from relatively unaltered clay minerals in alluvial sediments to electrically nonconductive alteration products such as epidote and feldspar.