Analysis of flow and thermal field in nanofluid using a single phase thermal dispersion model

Abstract

Flow and thermal field in nanofluid is analyzed using single phase thermal dispersion model proposed by Xuan and Roetzel [Y. Xuan, W. Roetzel, Conceptions for heat transfer correlation of nanofluids, Int. J. Heat Mass Transfer 43 (2000) 3701–3707]. The non-dimensional form of the transport equations involving the thermal dispersion effect is solved numerically using semi-explicit finite volume solver in a collocated grid. Heat transfer augmentation for copper–water nanofluid is estimated in a thermally driven two-dimensional cavity. The thermo-physical properties of nanofluid are calculated involving contributions due to the base fluid and nanoparticles. The flow and heat transfer process in the cavity is analyzed using different thermo-physical models for the nanofluid available in literature. The influence of controlling parameters on convective recirculation and heat transfer augmentation induced in buoyancy driven cavity is estimated in detail. The controlling parameters considered for this study are Grashof number (10 3 < Gr < 10 5), solid volume fraction (0 < ϕ < 0.2) and empirical shape factor (0.5 < n < 6). Simulations carried out with various thermo-physical models of the nanofluid show significant influence on thermal boundary layer thickness when the model incorporates the contribution of nanoparticles in the density as well as viscosity of nanofluid. Simulations incorporating the thermal dispersion model show increment in local thermal conductivity at locations with maximum velocity. The suspended particles increase the surface area and the heat transfer capacity of the fluid. As solid volume fraction increases, the effect is more pronounced. The average Nusselt number from the hot wall increases with the solid volume fraction. The boundary surface of nanoparticles and their chaotic movement greatly enhances the fluid heat conduction contribution. Considerable improvement in thermal conductivity is observed as a result of increase in the shape factor.