Abstract
The Six Sigma method using the DMAIC methodology is being applied for analyzing the reflow soldering process in an SMT assembly line. The Define phase (D) and Measure phase (M) were concluded, the Analysis (A) phase is being implemented, and the Improve (I) and Control (C) phases will be the next ones. Defects generated during the reflow process were classified and measured both on assembled memory modules and on virgin laminates that were passed through the oven during the reflow of these modules. Spots of solder and flux were found on the edge connector of the modules and also on the surface of the virgin laminates. It was found that these defects are generated inside the reflow oven, indicating that the oven is contaminated. Two solder pastes were analyzed and consequently, two temperature profiles were used. The amount of defects generated by the oven was found to be independent on the temperature profile. On the other hand the amount of defects depends on the solder paste that is used. The FMEA (Failure Mode and Effect Analysis) was also accomplished. As a result, the main failure modes of the reflow process were determined, namely, the heating rate, the soak temperature, the conveyor velocity, the reflow temperature, the reflow time, and the cooling rate.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
