Abstract
In this paper we present the results of the numerical simulation using wx-AMPS1D software of a solar cell based on hydrogenated amorphous silicon (a-Si: H / c-SiGe), the top layer has the largest band gap, while the bottom layer has the smallest bandgap. This design allows less energetic photons to pass through the upper layer(s) and be absorbed by the layer below, which increases the overall efficiency of the solar cell to obtain an efficiency high conversion rate. As the results, remarkable improvements on Voc, Jsc and FF have been achieved with the incorporation of n-c-SiGe layer, we achieved an efficiency of 11.93%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.