Abstract
Abstract The 3C (Computer, Communication and Consumer) product has the properties of being light, thin, short and small. In this study, numerical simulations of three-dimensional injection molding are used for thin-walled product. The governing differential equations are discredited by using control volume finite element method. This research points out the processing phenomenon of electronic dictionary battery covers in thin-walled injection molding. This research emphasizes the gate design of thin-walled injection molding for PC+ABS materials. The results show that the gate for single point of two sides is suitable on thin-walled injection molding by numerical simulation. The results also show that the processing is very well for thin-walled injection molding by numerical simulation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Communications in Heat and Mass Transfer
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
