Abstract
The condition for the designability and efficiency of the machining processes is that the part production process is chosen to meet the operational requirements based on the most accurate technological plans possible. One part of this is the planning of the required quality and roughness of the surfaces and achievement of the required values in the finishing. In this paper, a study on the predictability of surface roughness was performed using a CAD model based on theoretical roughness and validated by cutting experiments. The reported results show the effect of the feed rate change in face milling for two tools with different edge geometries in planes parallel to the feed direction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
