Analysis and fabrication of a small-scale radio-frequency balun for magnetic resonance imaging amplifier.

Abstract

In this study, the authors report the design and fabrication of a small mixed-integrated balun for magnetic resonance imaging (MRI). The device was designed by using the positive anti-symmetric coupling method, which applies the lump surface-mount technology capacitors as well as mirror-symmetric coupling strips that were etched on the top and bottom layers of a printed circuit board. The capacitors reduced the length of the coupling strips and compensated for imbalances in the phase and gain due to errors in the fabrication process. The structure and equivalent even-odd circuit model of the device was modeled and examined using commercial software to optimize the design parameters. Following this, the device was fabricated and its performance was assessed through measurements using a network analyzer. The results showed that imbalances in the gain and phase were lower than 0.1 dB and 1°, respectively, and the insertion loss and the input voltage standing-wave ratio (VSWR) were lower than 0.4 dB and -25 dB, respectively. More importantly, the device was small, with dimensions of 50 × 60 × 1.5mm. This makes it suitable for MRI applications involving highly integrated miniaturized systems. The proposed device was integrated into a 3.0T radio-frequency power amplifier (RFPA) and reduced the dimensions of its power modules by 20% compared with the traditional balun. Finally, the RFPA module was used in an 3.0T MRI system for imaging experiments, and the results showed that the balun can help obtain high-quality scanning images.