Abstract
The dead-time effect, as an intrinsic problem of the converters based on the half-bridge unit, leads to distortions in the converter output. Although several dead-time effect compensation or elimination methods have been proposed, they cannot fully remove the dead-time effect of blanking delay error, because the output current polarity is difficult detect accurately. This paper utilizes the zero-voltage-switching (ZVT) technique to eliminate the blanking delay error, which is the main drawback of the hard-switching inverter, although the technique initially aims to improve the efficiency. A typical ZVT inverter—the auxiliary resonant snubber inverter (ARSI) is analyzed. The blanking delay error is completely eliminated in the ARSI. Another error source caused by the finite rise- and fall-times of the voltage is analyzed, which was not considered in the hard-switching inverter. A compensation method based on the voltage error estimation is proposed to compensate the rise- and fall-error. A prototype was developed to verify the effectiveness of the proposed control. Both the simulation and experimental results demonstrate that the qualities of the output current and voltage in the ARSI are better than that in the hard-switching inverter due to the elimination of the blanking delay error. The total harmonic distortion (THD) of the output is further reduced by using the proposed compensation method in the ARSI.
Highlights
The half-bridge, as a basic unit, employs two stacked semiconductor switches connected across the DC voltage to realize energy transfer
Both the simulation and experimental results demonstrate that the qualities of the output current and voltage in the auxiliary resonant snubber inverter (ARSI) are better than that in the hard-switching inverter due to the elimination of the blanking delay error
total harmonic distortion (THD) of the output current is reduced to 0.712%
Summary
The half-bridge, as a basic unit, employs two stacked semiconductor switches connected across the DC voltage to realize energy transfer. Different commutation type leads to different voltage error caused by the dead-time This kind of dead-time effect is blanking delay error, which is the main error in the half-bridge-based topology [12]. The external resonant capacitors are always required to reduce the voltage changing rate of the switches, so that the turn-off loss and electromagnetic interference (EMI) can be reduced This will lead to output voltage distortion, which is caused by the finite commutation time. This kind of dead-time effect is quite different from that in the hard-switching inverters. The simulation and experiment are undertaken to verify the effectiveness of the proposed method
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.