Abstract
Utilization of used equipment for reducing waste is very important. The car alternator is one component of that can be used to increase its utilization. Modification of alternators in vehicles can be generator for wind power plants. The research done is to compare the alternator output voltage before modification with the alternator output after being modified. Modification of the alternator is carried out by the load variation method. Based on the results of the measurement the alternator before and after modification shows results that are directly proportional to the output. Alternator measurement at 1100 RPM rotation produces a voltage of 4.57 Volts before further modification and than after modification produces 14.56 Volts. Analysis of the results obtained resulted in an average difference of 2.8% so that it can be concluded that the modification has not achieved maximum results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: RELE (Rekayasa Elektrikal dan Energi) : Jurnal Teknik Elektro
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
