Abstract
Bearings are an essential component of rotating mechanical equipment. Traditional signal processing-based fault diagnosis methods usually require a massive labeled data for training, but bearings generally operate in the equipment under normal fault-free conditions. This paper proposes an improved adaptive batch normalization (AdaBN) transfer learning bearing fault diagnosis method for batch normalization (BN) in traditional deep learning architecture. The AdaBN network preprocesses the raw vibration signals, and then the preprocessed features are input to a depthwise sparable convolution neural model for training. Features are extracted by depthwise convolution and point convolution in the network. AdaBN can freeze all the parameters in the network except the BN layer. Finally, a small amount of labeled data is classified using transfer learning methods. A laboratory data set was used for validation, and the experimental validation showed that the accuracy of the bearing fault diagnosis method using AdaBN reached 85%.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
