Abstract
AbstractAn ultraviolet‐deposited MoO3 film is developed as anode interlayer based on molybdenum(V) chloride as precursor. The ultraviolet‐deposited MoO3 film is prepared from the precursor film (spin coated from its solution) with ultraviolet irradiation treatment, and the preparation process of the MoO3 film is facile, low cost, and compatible with mass production and flexible substrate. The composition of the MoO3 film is analyzed by X‐ray photoelectron spectroscopy. The work function as well as the surface morphology and wettability of indium tin oxide (ITO) modified by the MoO3 film are investigated by ultraviolet photoelectron spectroscopy, atomic force microscopy, and contact angle tester, respectively, where the analyses show the ITO modified by the MoO3 anode interlayer can offer excellent energy level alignment and interface contact with active layer. The photovoltaic performance of nonfullerene polymer solar cells (PSCs) based on the MoO3 anode interlayer is researched with typical and relatively low‐cost PBDB‐T:ITIC as active layer, and the ITO/MoO3‐based device shows the highest power conversion efficiency of 9.27% compared with the bare ITO‐based device (3.69%) and the ITO/PEDOT:PSS‐based device (9.15%). The results demonstrate the great potential of the ultraviolet‐deposited MoO3 film as anode interlayer for high‐performance PSCs.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
