Abstract
The realisation of wireless EEG systems suitable for long term monitoring requires low noise, low power and low voltage circuit design. Presented in this paper is a 1 V, 1.4 <i xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">μ</i> W chopper amplifier implemented in a 0.35 <i xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">μ</i> m CMOS process. The achieved input referred noise voltage is 1.5 <i xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">μ</i> V rms and the gain is 44 dB. Since the dynamic range of the input EEG signal is dominated by the offset voltage generated at the electrode-tissue interface, a novel input high pass filter has been designed. The required filter capacitance is limited to 40 pF by recognising that the input chopper switches can be combined with the amplifier input capacitance to emulate a large resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
