Abstract
Making a study of the design of a NC inserting PC open CNC system from the aspect of hardware and software, this paper adopted a programmable multi-axis controller (PMAC) to construct a hardware platform for the open CNC system on the mode of “PC + motion controller”. Introduction was made to a kind of way of implementation of the open CNC system. The developed system can satisfy the experimental requirements of the university’s numerical control laboratory and also be used to rebuild CNC systems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
