An Ion Selective Electrode Construction Based on Phosphomolybdic Acid for Atropine Sulfate Detection

Abstract

AbstractThis study presents an attempt has been carried out to fabricate ion‐selective electrodes (ISEs) for the determination of Atropine sulfate (AT) in pharmaceutical formulas. Three plasticizers; namely, di‐n‐butyl phthalate (DBP), bis (2‐ethyl hexyl) phthalate (BEP), nitrobenzene (NB), and tetrahydrofuran (THF) were used in the fabrication of the three ion selective electrodes after incorporating into polyvinyl chloride (PVC) and symbolized as E1, E2, and E3, respectively. Beyond evaluation of the three ISEs, it has been confirmed that one with DBP experienced the most Nernstian behaviour. For the electrode of interest, the slope and detection limit are 55.02 mV/decade and 1.1×10−6 M, respectively. The linear range was 1.0×10−2–1.0×10−5 M (R2=0.9999) with recording 5 s and 45 days; sequentially, for the response time and shelf life of E1 electrode. The sensor has experienced high selectivity for atropine sulfate, verifying from the selectivity coefficient data for a number of potential interferences. The statistical analysis using t‐test and F‐test indicates the eligibility of constructed electrode for utilization in field of pharmaceutical analysis. A satisfactory accordance has been obtained between the proposed electrode for atropine sulfate and the standard method. This methodology is supposed to be applicable in quality control and even clinical diagnosis.