An investigation on the relationship between grip, push and contact forces applied to a tool handle

Abstract

Owing to the strong dependence of the health risks associated with vibration exposure of the human hand and arm on hand force, a laboratory study was conducted to develop a methodology for measurement of the contact force at the tool handle–hand interface, and to identify the relationship between the contact force and the hand grip and push forces. A simulated tool handle fixture was realized in the laboratory to measure the grip and push forces using compression/extension force sensors integrated within the handle and a force plate, respectively. The contact force was derived through integration of the interface pressure over the contact area. These were measured using a capacitive pressure-sensing grid. The measurements were performed with 10 male subjects and three circular cross-section handles of different sizes under different combinations of grip and push forces. The hand–handle interface pressure data were analyzed to derive the contact force, as functions of the constant magnitudes of the grip and push forces, and the handle size. The results suggest that the hand–handle contact force is strongly dependent upon not only the grip and push forces but also the handle diameter. The contact force for a given handle size can be expressed as a linear combination of grip and push forces, where the contribution of the grip force is considerably larger than that of the push force. The results further suggest that a linear relation can characterize the dependence of the contact force on the handle diameter. The validity of the proposed relationship is demonstrated by evaluating the magnitudes of errors between the estimated contact forces with the measured data for the range of handle diameters, and grip and push forces considered in the study. Relevance to industryThe methodology proposed in this study can be applied to measure the effective hand–handle contact force at workplaces for assessing the health risks associated with exposure to hand-transmitted vibration exposure and hand–wrist cumulative trauma. The relationship proposed in the study could be effectively applied for estimating the hand–handle contact force from known grip and push forces that are conveniently and directly measurable in laboratory studies involving vibration analyses of the human hand, power tools and relevant vibration attenuation devices. It is expected to be most useful in field applications, where it could provide an estimate of the range of magnitudes of the hand-grip force applied to the handle of an actual tool, which is quite difficult and expensive to measure. The relationship is also expected to contribute to the on-going standardization efforts for defining a correction factor to account for the effects of hand force on the vibration transmission and hand injuries.