Abstract
This paper presents an experimental investigation on the influences of EDM parameters on machining time and surface roughness for machining Inconel 800.Inconel800is widely used in construction of equipment that must have high strength and resist carburization, oxidation and other harmful effects of high temperature exposure. The selected WEDM parameters are pulsed current (210,220 and 230A), pulse-on time (2,3.25, 4.5, 5.75, 7 and 8.25μs) and pulse-off time (19 and 46μs). It has been observed that surface roughness increases with the increase of pulse-on time and pulse current. Similarly machining time decreases with the increase of pulse current and pulse-on time. Conversely, a decreased value of pulsed current and pulse-on time results in a better surface finish and increased machining time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
