An Investigation of Lubricant Film Thickness in Sliding Compliant Contacts

Abstract

An optical interferometric technique has been used to investigate fluid film thickness in sliding, isoviscous elastohydrodynamic contacts (I-EHL). Monochromatic two-beam interferometry has been employed to map lubricant film thickness across a range of applied loads and entrainment speeds. The contact was formed between an elastomer sphere and plain glass disc, illuminated under red light, λ= 630 nm. Experimental work has employed sunflower oil and glycerol/water solutions as the test lubricants, due to their similar refractive indices and varying viscosity. A black-and-white-image-intensified camera has been employed to capture interference images and a computer processing technique used to analyse these images, pixel by pixel, and create film thickness maps based on their gray-scale intensity representations. Comparison of film thickness results to theoretical models shows reasonable qualitative agreement. Experimental results show both a reduced horseshoe, which is limited to the rear of the contact, and wedge-shaped film thickness profile within the Hertzian contact region. This is unlike conventional hard EHL contacts where the horseshoe-shaped pressure constriction extends around the contact toward the inlet. Experimental results suggest that film thickness profiles take on a convergent wedge shape similar to that used in many hydrodynamic bearings. It is likely that this wedge is largely responsible for generating fluid pressure and therefore the load-carrying capacity of the contact.