Abstract

Spoil piles in coal mine areas in north-central West Virginia suffer from numerous landslide problems. An investigation to determine the causes of these slides showed that the stratigraphic composition, the nature of the foundation soils, the seasonal high water table and the mining technique contributed to the instability. The presence of red shales is identified as a key problem. Several models of failure were investigated based on inclinometer data. These data suggest that multiple failure surfaces may develop in spoil piles. In such cases, the initial failure surface is better defined than other movement surfaces, which either represent subsequent failures that occur in response to placement of additional spoil materials, or are shear zones of readjustment following initial failure. Results show that failures are most likely initiated along the spoil-natural ground interface and propagate slowly into the spoil mass.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.