An investigation into the likely impact of oxy-coal retrofit on fire-side corrosion behavior in utility boilers

Abstract

Real-time electrochemical measurements of corrosion rate were performed to evaluate the respective corrosion rates of one boiler waterwall material (SA210) and three boiler superheater materials (T22, P91 and 347H) while firing Utah Western bituminous, Illinois high-sulfur bituminous and Powder River Basin (PRB) sub-bituminous coals in a 1.5 MW pulverized coal-fired furnace. The raw average measured corrosion rates were very low, between 0.0003 and 0.016 mm/year (0.012 and 0.63 mils/year) for most materials under air- and oxy-fired conditions. For some high-sulfur conditions measured corrosion rates were as high as 0.72 mm/year (28 mils/year). Waterwall corrosion rates decreased consistently when converting from air- to oxy-firing while superheater corrosion rates generally increased, although they were less than twice the air-fired rate under most conditions. Corrosion rates for the lower alloyed materials (SA210 and T22) increased significantly during transients from reducing to oxidizing conditions. Measured increases in the corrosion rate of 347H material under high sulfur and low temperature conditions, and associated decrease in corrosion rate at higher temperatures on this alloy, were consistent with the formation of trisulphates in the superheater deposits. The increase of corrosion rate with increased metal temperatures was demonstrated, as was the consistently repeatable nature of the observed results.