Abstract
Lateral compression is one of the most important mechanical aspects of fabrics, which reflects their handle. Fabric compressional features depend on the compressional characteristics of constituent yarns and the fabric structure. In order to consider the effect of fabric structural parameters on its compressional properties, woven fabrics with five different weave patterns (plain, hopsack 2/2, twill 2/2, twill 3/1, warp rib 2/2) were produced with three different nominal weft densities (12, 15, 18 cm−1). The compressional properties of produced fabrics were evaluated at different pressure values using a conventional fabric thickness tester. It was observed that increasing the weft density leads to decrease in the dissipated compression energy as well as the compressibility of the fabric, while the thickness recovery of the fabric increases. Moreover, the plain woven fabric exhibited the lowest dissipated compression energy and compressibility, while the highest thickness recovery. Besides, at the low pressure level, the fabrics with the lower weft densities demonstrate the higher thickness. By increase in the pressure level, the fabric thickness decreases by decreasing the weft density.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
