Abstract
This paper is concerned with a comparative analysis of modern cement grinding systems, namely, combined grinding (Comflex®), high-pressure roll mill (HPRM) grinding, and horizontal roller mill (Horomill®) grinding. Cement production trials were run with these grinding systems in the same cement plant by using the same clinker/gypsum feed to produce cements of almost identical chemical compositions and similar Blaine fineness values of about 3600cm2/g. The grinding systems were compared in terms of specific energy consumption and mortar properties of the produced cements. The specific energy consumption and the cement setting times increased in the order of combined grinding, HPRM grinding, and horizontal roller mill grinding. No significant difference was detectable among the water demands of the cements from the three grinding systems. The HPRM cement was superior in strength development, particularly at early ages.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
