Abstract
Fracture or carious lesions in an abutment tooth may require the fabrication of a crown under an existing removable partial denture. Typically, once the crown has been fabricated, the prosthesis will need to be modified or refabricated. However, if the partial denture is in good clinical condition, special techniques may be applied to make the new crown fit the existing prosthesis. This article describes a straightforward indirect-direct technique for fabricating a cast metal crown under an existing removable partial denture with hot water. The technique does not require expertise or any special device and can be performed chairside by general dentists.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.