An in-vitro three-dimensional surgical simulation technique to predict tibial tunnel length in transtibial posterior cruciate ligament reconstruction

Abstract

BackgroundDuring the transtibial posterior cruciate ligament (PCL) reconstruction, drilling depth excessively longer than the tibial tunnel length (TTL) is an important reason to cause popliteal neurovascular bundle injury when preparing the tibial tunnel. This study aims to develop an in-vitro three-dimensional surgical simulation technique to determine the TTL in anteromedial (AM) and anterolateral (AL) approaches.MethodsA total of 63 knees’ 3-dimensional (3D) computed tomography models were included in this study. The SuperImage system was used to reconstruct the 3D knee model and locate the tibial PCL site. The established 3D knee model and the coordinates of the tibial PCL site were imported into Rhinoceros 3D modeling software to simulate AM and AL tibial tunnel approaches with different tibial tunnel angles (TTA). The TTL and the tibial tunnel height (TTH) were measured in this study.ResultsIn AM and AL tibial tunnel approaches, the TTL showed a strong correlation with the TTA (for AM: r = 0.758, p < 0.001; for AL: r = 0.727, p < 0.001). The best fit equation to calculate the TTL based on the TTA was Y = 1.04X + 14.96 for males in AM approach, Y = 0.93X + 17.76 for males in AL approach, Y = 0.92X + 14.4 for females in AM approach, and Y = 0.94X + 10.5 for females in AL approach.ConclusionMarking the TTL on the guide pin or reamer could help to avoid the drill bit over-penetrated into the popliteal space to damage the neurovascular structure.