An in-flight investigation of a turbulent boundary layer at Reynolds numbers up to hbox {Re}_{theta }=49,400

Abstract

The ongoing attempts to gain access to the realm of high Reynolds number turbulence have resulted in the dedicated development of major experimental facilities and novel diagnostic methodologies as well as in the probing of atmospheric surface flows. In contrast to this, the presented study discusses the feasibility of an in-flight laboratory for Reynolds number investigations up to rm {Re}_{theta },le ,49,400. The underpinning velocity data were obtained in flight tests by two moveable differential pressure probes and a stereo Particle Image Velocity (sPIV) system. The region of interest was located far downstream of the aircraft’s nose within the fuselage boundary layer. The pressure probes scanned the full boundary layer while the sPIV system remained fixed at certain wall-normal locations. The velocity data acquired exhibits distinct characteristics within the defect layer that deviate from Coles’ classical description of the wake. Furthermore, the streamwise turbulence intensities show a pronounced ‘outer peak’ further away from the wall at y^{+}=2000-5000 . The measurements were conducted under authentic flight conditions with an increased level of free-stream turbulence. These boundary conditions enabled an analysis of turbulent flows that are of relevance for various aeronautical applications. The manuscript elaborates on the main findings of this experimental study by presenting the velocity profiles captured by the moveable pressure probe system and samples of sPIV data. The capabilities and limitations of a flying laboratory for the investigation of high Reynolds number turbulence are discussed in detail.Graphic