Abstract

The problem of sequential fault detection and isolation in multiple data streams is considered. In this work, it is assumed that many independent parallel data streams, each of which has a (possibly infinite) change point, are sequentially observed with a maximum sampling constraint. The pre-change data follow a known distribution, and the post-change data follow one of J possible distributions. A sequential procedure is proposed to detect the changes for all data streams, and to isolate the types of changes upon their detection. The sequential procedure is shown to control the false discovery rate. An asymptotic upper bound on the average detection delay over the parallel data streams is also derived. A simulation study is presented to illustrate the proposed procedure and to corroborate the analysis.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.