Abstract
This study experimentally investigated the combined effects of the wall temperature (Tw0) and the orifice-to-wall distance (H/D) on the flow and heat transfer characteristics of an impinging synthetic jet. Thermographic phosphor thermometry (TPT) was used to measure the wall surface temperature, and the quantitative flow velocity was obtained using time-resolved particle image velocimetry (PIV). A cavity-diaphragm actuator was employed to generate a round synthetic jet to impinge onto a heated wall that was coated with Mg4FGeO6:Mn (MFG) for use as a temperature sensor. Three orifice-to-wall distances (H/D = 10, 15, and 20) and three wall temperatures (Tw0 = 60 °C, 90 °C, and 120 °C) were tested for comparison, whereas the the operating conditions of the incident synthetic jet were kept constant. It was found that the maximum temperature drop at the stagnation point could reach approximately 50°C although the orifice-to-wall distance was relatively large in this study, which indicated a good cooling performance of the synthetic jet. The penetration of the wall shear layer played an important role on the cooling performance of the impinging synthetic jet. For a heated wall with high Tw0, the enhanced buoyancy and thermal boundary layer resulted in the formation of a strong wall shear layer, which was more difficult for the impinging synthetic jet to affect or penetrate. For a large H/D, the vortex rings of the synthetic jet lose coherence completely before impacting the wall. Thus, they have no ability to penetrate the wall’s shear layer to interact with it directly. As a result, the cooling performance of the impinging synthetic jet gradually decreased as both Tw0 and H/D increased. In particular, the maximum cooling effect by the synthetic jet impingement can achieve 64% of the theoretical maximum.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.