Abstract
In injection molding, the ejection forces decrease when the surface roughness of mold decreases. However, the ejection forces increase contrary in the area of surface roughness is less than 0.2 μmRa. Several kinds of PVD films are coated on the mold cores to prevent the increasing of ejection forces. Some of these PVD films showed effective prevention of increasing of ejection forces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
