Abstract
Winglets have been employed in the aviation industry to reduce vortices generated at aircraft wings, decreasing drag, and hence increasing fuel economy. For rotating applications previous experimental and numerical studies addressed the application for wind turbines and suggested winglets facing backwards on the suction side of a blade could increase the power capture. This paper presents experimental work using a scale 3-bladed horizontal axis tidal turbine. An oil-based paint flow visualisation coupled to blade thrust and torque measurements helped to identify the mechanism behind the phenomenon affecting the performance of winglets facing the suction side of a turbine blade. The results show that on average a winglet facing downstream decreases the power coefficient 1–2% and increases the thrust coefficient up to 6% for tip speed ratios 5.0–7.0. On the other hand, a symmetrically mirrored winglet facing upstream increased the power coefficient by 1–2%, and the thrust coefficient by 3–4%. Winglets have the potential to provide a meaningful increase to power capture at minimal additional capital cost without increasing rotor diameters. Further work to optimize pressure‐side winglets should be conducted.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
