Abstract
The paper addresses the mechanical behavior of carbon steel 20 in asymmetric loading under the conditions of plane stress state that occurs in a thin-walled specimen in tension–compression and alternating torsion. The asymmetric cyclic loading of specimens was carried out in a stress-controlled mode along three paths with a frequency of 0.1 Hz with a base up to 1200 cycles. Cyclic stress–strain diagrams have been constructed for the specimens under tension–compression, alternating torsion, and proportional loading. The curves of von Mises equivalent ratcheting strains have been plotted. The highest ratcheting rate is shown to take place in the tension–compression loading case.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
