Abstract
The effectiveness of DC power bus decoupling is impacted by the inductance associated with interconnect vias in printed circuit boards (PCBs). Adequate characterization of these interconnects is necessary to facilitate modeling and simulation, and to assess the effectiveness of added decoupling. A measurement procedure is presented for determining the series inductance and resistance of an interconnect with a network analyzer. The validity and limitations of the procedure are discussed. Experimental results of interconnect parameters on an 8/spl times/10 in ten-layer test-board corroborate those measured with a precision impedance analyzer. The measured interconnect values are used to simulate several cases of power-bus decoupling which show good agreement with two-port swept frequency measurements.
Paper version not known (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Electromagnetic Compatibility
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
