An experimental investigation on the effectiveness of damping changes for damage detection in a Fibre Reinforced Plastic Plate

Abstract

Fibre reinforced plastics (FRP) are extensively used because of their high specific strength and stiffness. However, throughout their service life, such materials are susceptible to damages, which when accumulated may result in catastrophic failure. Studies on effects of stiffness loss due to damage has been exercised by quite a large number of researchers but very less investigators have involved the variations in dissipative behaviour in combination with such stiffness loss. However, damage in these structures not only causes local reduction of stiffness but is also observed with increased dissipation behaviour. One of the most convenient ways to carry out health monitoring exercise to detect damages is to conduct systematic vibration testing. The present study investigates the likely changes in natural frequencies and mode shapes of a rectangular FRP composite plate along with damping factors due to the induced damage. The FRP plate considered has been modal tested and dynamic responses i.e., natural frequencies, mode shapes and modal damping factors are derived through curve-fitting technique from the frequency response function measurements. In this study, changes in dynamic responses due to a locally induced damage in the FRP plate is studied. For this, in order to maximize the effects of local reduction in the stiffness on the modal parameters, a partial-cut is provided in a localised region of the plate in the first damage case. In the second damage scenario, the partially-cut area has been filled with epoxy resin matrix to create a region with localised change in material properties and with limited stiffness loss. Damping changes has been observed to be significant and more sensitive than variations in natural frequencies and mode shapes. The study suggests that damping parameters along with stiffness changes together can be put into practice to develop an effective vibration-based health monitoring scheme