Abstract
In this article, the effect of bolt clamping force on the fatigue life of bolted double shear lap joints was investigated. To do so, fatigue tests were carried out on the bolt clamped double shear lap joint specimens made of aluminum alloy 2024-T3. These fatigue tests were conducted with applied torques of 0.25, 2 and 4 N m at different cyclic longitudinal load levels in un-lubricated and lubricated states. From these tests the stress–life ( S– N) data for different clamping forces for un-lubricated and lubricated states were obtained. The results show that clamping force increases fatigue life compared to clearance fit specimens. In general, at higher tightening torque higher fatigue lives were achieved, however, below a certain load level the life improvement was discontinued because of fretting phenomenon. Also lubricating the parts of the specimens reduces the advantage of clamping force or torque tightening.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.