An experimental investigation of dynamic crack propagation in a brittle material reinforced with a ductile layer

Abstract

The fracture behavior of a dynamically loaded edge crack in a brittle-ductile layered material, as a function of applied loading rate, was experimentally investigated. Layered specimens were prepared by sandwiching a thin layer of ductile aluminum between two thick layers of brittle Homalite-100. The layers were bonded using Loctite Depend 330 adhesive, and a naturally sharp edge crack was introduced in one of the Homalite-100 layers. These single-edge notched specimens were loaded in dynamic three-point bending using a modified Hopkinson bar. The fracture process was imaged in real time using dynamic photoelasticity in conjunction with digital high-speed photography, and the applied load and load-point displacement histories were determined from the strain signals recorded at two locations on the Hopkinson bar. The results of this study indicated two distinct mechanisms of dynamic failure, depending on the applied loading rate. At lower loading rates, the starter crack arrested on reaching the aluminum layer and then caused delamination along the aluminum–Homalite interface. On the contrary, as the loading rate was increased, interfacial delamination was followed by crack re-initiation in the Homalite layer opposite to the initial starter crack. It was determined that the times required for crack initiation, delamination and crack re-initiation decreased as the loading rate was increased. However, it was also observed that the applied load values associated with each event increased with increasing loading rate. These observations indicate that both the dynamic failure process and plausibly the failure mode transition are affected by the rate-dependent properties of Homalite, aluminum and the interfacial bond. Finally, based on the measured peak loads and the observed failure mechanisms it was concluded that the incorporation of a thin ductile reinforcement layer can increase both the overall fracture toughness and strength of a nominally brittle material.