Abstract

Cups having a height/diameter ratio greater than unity cannot as a rule be produced from flat circular blanks in a single stage, and redrawing in one or more operations has to be carried out until the desired shape of the shell is attained. In this paper an account is given of an experimental investigation into the forces, work, and strains involved in the first redrawing process.The work was carried out in an experimental crank press (Seed and Swift 1950)‡ of 50 tons nominal capacity, and was based on a first-stage cup diameter of 4 inches. Brass, mild steel and aluminium (in two tempers) were used.The conditions examined include the direct and reverse methods of redrawing, first-stage drawing ratio, inter-stage heat-treatment, punch profile radius, first-stage punch-die clearance, redrawing ratio, blank thickness, material, and temper.It is thought that the results are sufficiently accurate and detailed to give a reasonably complete insight into the redrawing process, and conclusions have been drawn to ...

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.