Abstract
Assessing the performance of spectroscopic x-ray detectors (SXDs) requires measurement of the frequency-dependent detective quantum efficiency (DQE). Analytical expressions of the task-based DQE and task-independent DQE of SXDs have been presented in the literature, but standardizable experimental methods for measuring them have not. The task-based DQE quantifies the efficiency with which an SXD uses the x-ray quanta incident upon it to either quantify or detect a basis material (e.g., soft tissue or bone) of interest. The task-independent DQE is akin to the conventional DQE in that it is independent of the basis material to be detected orquantified. The purpose of this paper is to develop an experimental framework to present a method for experimental analysis of the DQE of SXDs, including the task-based DQE and task-independentDQE. We develop methods to measure the frequency-dependent DQE for task of quantifying or detecting a perturbation in a known basis material. We also develop methods for measuring a task-independent DQE. We show that the task-based DQEs and the task-independent DQE can be measured using a modest extension of the methods prescribed by International Electrotechnical Commission (IEC). Specifically, measuring the task-independent DQE requires measuring the modulation transfer function (MTF) and noise power spectrum (NPS) of each energy-bin image, in addition to the cross NPS between energy-bin images. Measuring the task-based DQEs requires an additional measurement of the transmission fraction through a thin basis-material absorber. We implemented the developed methods using standardized IEC x-ray spectra, aluminum (Al) and polymethyl methacrylyte (PMMA) basis materials, and a cadmium telluride (CdTe) SXD equipped with two energy bins and analog charge summing (ACS) for charge-sharing suppression. We also performed a regression analysis to determine whether or not the task-independent DQE is predictive of the task-basedDQEs. Experimental results of the task-based DQEs were consistent with simulation results presented in the literature. In general, and as expected, ACS increased the task-based DQEs and task-independent DQE. This effect was most pronounced for quantification tasks, in some instances yielding a five-fold increase in the DQE. For both spectra, with and without ACS for charge sharing correction, the task-based DQEs were linearly related to the task-independent DQE, as demonstrated by R2 -values ranging from 0.89 to 1.00. We have extended experimental DQE analysis to SXDs that count photons in multiple energy bins in a single x-ray exposure. The developed framework is an extension of existing IEC methods, and provides a standardized approach to assessing the performance ofSXDs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.