Abstract
Aircraft manufacturing involves drilling of large number of holes, in which the joint can be critically affected by the quality of the hole. Effect of drill geometry on drilling of glass/epoxy laminates using twist, Zhirov and Multifaceted Drills (MFD), has been studied. The thrust force and hole quality were compared for each drill geometry. Zhirov drill cuts the hole with less force and best surface finish. MFD produces less delamination when compared with the other geometries. ANOVA was used to study the effect of drill geometries, spindle speed, and feed rate on thrust force, surface finish and delamination factor.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Materials and Product Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
