Abstract
Investigations into the various properties of granular matter composed of particles with defined shapes have gained increasing attention. Additive manufacturing, with its freedom of shape and rapid prototyping capabilities, has significantly contributed to these studies. However, this technique may introduce defects in the manufactured particles, which can significantly affect the properties of granular materials. The extent of these defects on particles of different shapes is investigated here. Particles of various shapes (cube, octahedron, quatropod, stellated octahedron, tetrahedron, and tetrapod) were manufactured and subsequently imaged using micro-Computed Tomography. The surface roughness, solidity, and convexity of the particles were quantified. Discrete element simulations of granular bed porosity, utilizing both idealized and real particle shapes, were conducted with different surface mesh resolutions and frictional parameters. A clear influence of the manufacturing process on the packing properties of 3D printed particles was identified. This influence is not uniform across all shapes and is directly correlated with the particle convexity. For numerical simulations, a shape-dependent correction of particle density and surface characteristics are imperative for each shape under consideration, despite the fact that the particles were manufactured using the same technique and material.Graphic abstract
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
