Abstract
In order to raise a fatigue resistance the calculation-experimental method of parts surface thermo chemical machining efficiency has been carried out. The employment of two types of reference specimens in experiments has been substantiated. The employment of smooth reference specimens for a determination of residual stresses in a surface layer and of corset reference specimens for fatigue tests has been recommended. The results of experimental study of two types of thermo chemical machining (cementation and nitriding) influence on a fatigue resistance of corset specimens made of high-strength allows ВКС-5 и ВНС-17 have been used in the work. . The calculations of the study have been carried out by the Finite Elements Modeling method using the calculation complexes ANSYS and PATRAN/NASTRAN. The residual strained state modeling is carried out by thermo elasticity method. On grounds of conducted calculation its been stated that an axial residual stresses distribution in a dangerous (smallest) section of a corset specimen doesnt practically differ from a similar distribution in smooth specimens. An endurance limit increment due to corset specimens hardening was determined with use of the average integral residual stresses criterion. Carried out results let also maintain that the optimal regimes of thermo chemical machining are the regimes under which average integral residual stresses are maximum.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
