Abstract
Aiming at the problem of noise suppression in power lines, traditional noise suppression methods need to know prior knowledge and other defects. In this paper, blind source separation methods that do not need prior knowledge are selected. In the case of low signal-to-noise ratio, the basic independent component analysis algorithm has poor denoising effect. Therefore, this paper proposes a joint independent component analysis algorithm based on Wavelet denoising and Power independent component analysis (WD-PowerICA). In this work, firstly, the pseudo observation signal is constructed by weighted processing, and the blind separation model of single channel is transformed into a multi-channel determined model. Then, the proposed WD-PowerICA algorithm is used to separate noise and source signals. Finally, the simulation results demonstrate that the proposed algorithm in this paper can effectively separate noise and source signal under low SNR. At the same time, the stronger the α pulse noise is, the closer the WD-PowerICA separated signal is to the source signal. The proposed algorithm is better than the state of the art PowerICA algorithm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.