Abstract
Wearable energy harvester offers clean and continuous power for wearable sensors or devices, and plays an important role in a wide range of applications such as the health monitoring and motion track. In this study, we investigate a small electromagnetic resonance wearable kinetic energy harvester. It consists of a permanent magnet (PM) supported by two elastic strings within a rectangular box form a 3-degree-of-freedom (3-DoF) vibrator. Copper windings are attached to the outer surface of the box to generate electrical energy when the PM is forced to vibrate. To minimize any frictional losses, ferrofluid is used such that the poles of PM are cushioned by the ferrofluid, to the effect that the PM will not touch the inner of the box. Simulation results show that the ferrofluid can keep the PM ‘contactless’ from the box even subject to 10 times gravity acceleration. A prototype is built and tested under different loading conditions. Resistance load experimental results indicate the proposed harvester can generate 1.1mW in walking condition and 2.28mW in running condition. An energy storage circuit is employed and the energy storage experimental results show that the average storage power during walking and running conditions are 0.014mW and 0.149mW respectively. It is shown that the developed harvester can be readily attached on a shoe to offer continuous power supply for wearable sensors and devices.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
