An Electrochemical Cell for Operando Grazing-Incidence X-Ray Absorption Spectroscopic Studies of Low-Loaded Electrodes

Abstract

X-ray absorption spectroscopy (XAS) is a powerful technique that can provide element specific information on the local electronic and structural properties of newly developed electrocatalysts, especially when performed under operating conditions (i.e., operando). However, the large amounts of catalyst typically needed to achieve sufficiently high spectral quality and temporal resolution can result in working electrodes of several micrometers in thickness. This can in turn lead to an inhomogeneous potential distribution across the electrode, delamination and/or incomplete utilization of the catalyst layer, severe bubble formation and accumulation due to poor mass transport properties.[1, 2] In addition, the activity and selectivity of a catalyst are often measured in a different cell geometry (e.g., using rotating disk electrodes (RDEs)), leading to uncertainties in comparison with the results inferred from spectroscopic data.[3]To tackle these problems we have developed a new spectroelectrochemical XAS flow cell that enables spectral acquisition in fluorescence mode using an X-ray beam incidence angle of ≤ 0.1° with regards to the working electrode’s substrate plane, i.e., in a so called grazing incidence (GI) configuration (see Figure 1). In this acquisition configuration we successfully tracked the formation of palladium hydride with a time resolution of 10 seconds per spectrum while using a Pd-loading as low as 50 µgPd∙cm-2. Moreover, the careful design of the working electrode flow field allows the study of faradaic processes (e.g., O2-reduction) under mass-transport controlled conditions entailing currents comparable to those attained in RDE measurements (≤ 10 mA∙cm−2). The combination of these features with an ion-conductive membrane to separate the working- and counter-electrode compartments additionally enables the detection of gaseous products (e.g., from CO2-electroreduction) by degassing them out of the electrolyte and analyzing them in time-resolved fashion by means of mass spectrometry.[4] References Diklić, N., et al., Potential Pitfalls in the Operando XAS Study of Oxygen Evolution Electrocatalysts. ACS Energy Letters, 2022. 7(5): p. 1735-1740. Diercks, J.S., et al., Spectroscopy vs. Electrochemistry: Catalyst Layer Thickness Effects on Operando/In Situ Measurements. Angew Chem Int Ed Engl, 2023: p. e202216633. Diercks, J.S., et al., Interplay between Surface-Adsorbed CO and Bulk Pd Hydride under CO2-Electroreduction Conditions. ACS Catalysis, 2022: p. 10727-10741. Khanipour, P., et al., Electrochemical Real-Time Mass Spectrometry (EC-RTMS): Monitoring Electrochemical Reaction Products in Real Time. Angew Chem Int Ed Engl, 2019. 58(22): p. 7273-7277 Figure 1