Abstract

Due to the feasibility of an electrically rechargeable zinc/air cell made of a zinc foil as active material, an aqueous choline acetate (ChAcO) mixture as an electrolyte and a spinel MnCo2O4 (MCO) and NiCo2O4 (NCO) as a bi-functional oxygen catalyst was investigated in this work. The 30 wt.% water-containing aqueous ChAcO solution showed high contact angles close to those of KOH favoring triple-phase boundary formation in the gas diffusion electrode. Conductivity and pH value of 30 wt.% H2O/ChAcO amounted to 5.9 mS cm−1 and 10.8, respectively. Best results in terms of reversible capacity and longevity of zinc/air cell were yielded during 100 h charge/discharge with the MnCo2O4 (MCO) air electrode polarization procedure at 100 µA cm−2 (2.8 mA g−1zinc). The corresponding reversible capacity amounted to 25.4 mAh (28% depth of discharge (DOD)) and the energy efficiency ranged from 29–54% during the first and seventh cycle within a 1500 h polarization period. Maximum active material utilization of zinc foil at 100 µA cm−2 was determined to 38.1 mAh (42% DOD) whereas a further charging step was not possible due to irreversible passivation of the zinc foil surface. A special side-by-side optical cell was used to identify reaction products of the zinc/air system during a single discharge step in aqueous ChAcO that were identified as Zn(OH)2 and ZnO by Raman analysis while no carbonate was detected.

Highlights

  • The demand for efficient, low-cost, and energy storage systems for portable, mobile, and stationary applications is increasing dramatically

  • The corresponding reversible capacity amounted to 25.4 mAh (28% depth of discharge (DOD)) and the energy efficiency ranged from 29–54% during the first and seventh cycle within a 1500 h polarization period

  • A special side-by-side optical cell was used to identify reaction products of the zinc/air system during a single discharge step in aqueous ChAcO that were identified as Zn(OH)2 and ZnO by Raman analysis while no carbonate was detected

Read more

Summary

Introduction

The demand for efficient, low-cost, and energy storage systems for portable, mobile, and stationary applications is increasing dramatically. A traditional system such as lead-acid and Ni-Cd are dominating the market for electricity supply of back-up units, a pallets transporter, energy storage of solar collectors, and brake energy recuperation in trains. Many efforts aimed to develop alkaline zinc/air battery whose theoretical capacity amounts to 820 mAh g−1 zinc. With the exception of the primary zinc/air battery for hearing aids devices, wide introduction of electrically rechargeable systems into the consumer market is hindered by numerous inherent technical drawbacks such as passive layer formation and dendrite growing at the metal electrode [2], electrolyte evaporation and contamination, pore plugging at the gas diffusion electrode (GDE) due to flooding and carbonate formation [3], and insufficient kinetics and stability

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call